ENVIRONEX STONESEAL is a water-based sealer used for the sealing of walls and floors against penetration of stains, water, oils, greases etc.
STONESEAL is a one resin system with integral components activated by evaporation of moisture and exposure to light.
It finds its main use in sealing of sandstone pavers, limestone, blockwork, brickwork and stone walls and floors, where a high gloss and wet look associated with solvent based sealers is not desired.
However, it can be used effectively in the protection of concrete and brick paving areas, masonry walls where penetration of moisture is a problem and stone surfaces where damage by oils, grease and the occasional spillage of petrol needs to be prevented.
STONESEAL can be used both internally and externally and is not subject to yellowing.
Apply STONESEAL to clean stone at the rate of 100 250mls per square metre per coat with two to three coats being recommended to ensure saturation of surface.
For high-density stone surfaces, STONESEAL may be diluted with water at the rate of no more than 50:50, with the number of coats of the diluted product adjusted accordingly to ensure saturation of the surface.
Apply by airless spray, brush, broom or lambswool applicator, DO NOT USE A ROLLER.
Wash out implements in water prior to drying. For optimum protection ensure full saturation and complete film formation.
IMPORTANT NOTICE TO CUSTOMER
Since the use of this product is beyond the control of either seller or manufacturer, their only obligation shall be to replace any quantity of product which is proven defective.
They cannot assume any risk or liability in excess of the purchase price of the product itself, which does not include labour or any consequential damages resulting from the use of this product.
Determining the suitability of this product for any intended use shall be solely the responsibility of the user.
ALWAYS TEST FIRST.